StereoPi Specifications

From StereoPi Wiki
Revision as of 17:40, 24 April 2019 by Realizator (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Features & Specifications

Raspberry Pi Compatibility:

  • Raspberry Pi Compute Module 1
  • Raspberry Pi Compute Module 3
  • Raspberry Pi Compute Module 3 Lite
  • Raspberry Pi Compute Module 3+ 8 GB / 16 GB / 32 GB eMMC flash
  • Raspberry Pi Compute Module 3+ Lite

Dimensions:

  • width x length: 90 mm x 40 mm
  • height: 23 mm (standard edition) / 15 mm (slim edition)

Video:

  • input: two 15-pin CSI-2 camera connectors
  • output: HDMI

Camera Support:

  • Raspberry Pi camera V1 (OV5647 sensor)
  • Raspberry Pi camera V2 (Sony IMX 219 sensor)
  • HDMI video capture module (single mode, on Toshiba TC358743XBG chip)

Connectivity:

StereoPi Regular Edition:

  • GPIO: 40-pin classic Raspberry Pi header
  • USB: 2 x USB Type-A, 1 x USB pin header
  • Ethernet: RJ45 jack

StereoPi Slim Edition:

  • GPIO: no GPIO pins; soldering points for 40 GPIO
  • USB: 1 x USB pin header; soldering points for 2 USB Type-A connector
  • Ethernet: no RJ45 jack; soldering points for RJ45 jack

Storage:

  • microSD card slot (accessed by Raspberry Pi CM3/3+ Lite)

Power:

  • 5 VDC input via two-pin header
  • manual power switch

Software:

  • firmware update via Micro USB connector
  • runs standard Raspbian

StereoPi Pinout

StereoPi Front Noted
StereoPi Top Noted

A. boot mode jumper

B. camera 1 CSI-2 connector

C. micro USB (for firmware upload)

D. 5 VDC power connector

E. power switch

F. microSD slot

G. RJ45 Ethernet jack

H. dual USB Type-A connector

I. HDMI out

J. USB port pin header

K. camera 2 CSI-2 connector

L. 40-pin RPi GPIO header

M. RPi Compute SO-DIMM connector