Difference between revisions of "StereoPi v2 Quick Start Guide"
Jump to navigation
Jump to search
Realizator (talk | contribs) (1st commit) |
Realizator (talk | contribs) m |
||
Line 7: | Line 7: | ||
# Take the CM4 module so that the triangle PCB antenna and the power circuit (a group of 5 black components) are faced to the left. | # Take the CM4 module so that the triangle PCB antenna and the power circuit (a group of 5 black components) are faced to the left. | ||
# Put the CM4 module on the connectors and gently press the bottom until you hear a click. After that, do the same with the top part of the CM4. | # Put the CM4 module on the connectors and gently press the bottom until you hear a click. After that, do the same with the top part of the CM4. | ||
+ | |||
+ | == Power switch == | ||
+ | |||
+ | Please install a jumper to the pins near the USB C connector. | ||
+ | |||
+ | [https://youtu.be/Z3LX-8qM8HY YouTube video: Power Switch] | ||
+ | |||
+ | Note: advanced users can use external buttons or equipment to turn on/off the board. | ||
+ | |||
+ | |||
+ | == How to connect power == | ||
+ | |||
+ | We recommend using the UCB C power supply unit. | ||
+ | |||
+ | If the power jumper is installed, the board will boot as soon as you connect the power cable. | ||
+ | |||
+ | [https://youtu.be/2iCTPc4-hn4 YouTube video: USB C power] | ||
+ | |||
+ | Advanced users: you can use either a USB C cable or the JST-EHR2 cable. You can also use them at the same time and hot-swap on the go. | ||
+ | [https://youtu.be/bIpSlPUVfRI YouTube video: Hot Swap Power] |
Revision as of 12:33, 22 September 2021
How to install RPi Compute Module 4 (CM4)
- Disconnect all external equipment and power.
- Put the board upside down so that the USB C port is facing to the left.
- Take the CM4 module so that the triangle PCB antenna and the power circuit (a group of 5 black components) are faced to the left.
- Put the CM4 module on the connectors and gently press the bottom until you hear a click. After that, do the same with the top part of the CM4.
Power switch
Please install a jumper to the pins near the USB C connector.
Note: advanced users can use external buttons or equipment to turn on/off the board.
How to connect power
We recommend using the UCB C power supply unit.
If the power jumper is installed, the board will boot as soon as you connect the power cable.
Advanced users: you can use either a USB C cable or the JST-EHR2 cable. You can also use them at the same time and hot-swap on the go. YouTube video: Hot Swap Power