Difference between revisions of "SLP2 (StereoPi Livestream Playground v2)"
Realizator (talk | contribs) m (→Ethernet) |
Realizator (talk | contribs) m (→WiFi access point) |
||
Line 7: | Line 7: | ||
=== WiFi access point === | === WiFi access point === | ||
+ | |||
+ | SLP2 has pre-configured access point mode by default. That is after the first boot, you should see an access point named "Cosmostreamer." Use the "1234512345" password to access it. You can change the access point name and password in the configuration file "cosmostreamer.conf" in the /boot partition of the micro SD card (or eMMC). Here is how this section looks like: | ||
+ | |||
+ | # Wi-Fi access point interface | ||
+ | # disabled if empty, int - Internal Wi-Fi, ext - External USB Wi-Fi | ||
+ | ap_iface=int | ||
+ | |||
+ | # Wi-Fi access point SSID | ||
+ | ap_ssid="cosmostreamer" | ||
+ | |||
+ | # Wi-Fi access point password | ||
+ | ap_psk="1234512345"` | ||
+ | |||
+ | Examples: | ||
+ | To disable access point use: | ||
+ | |||
+ | ap_iface= | ||
+ | |||
+ | To enable access point using external WiFi (USB dongle) use: | ||
+ | ap_iface=ext | ||
+ | |||
+ | To enable access point using internal WiFi installed on CM4 use: | ||
+ | ap_iface=int | ||
+ | |||
+ | Note: please check that your USB WiFi dongle supports AP mode and that RaspiOS support the dongle's chipset! | ||
+ | |||
=== WiFI connection to router === | === WiFI connection to router === | ||
Revision as of 15:19, 5 October 2021
Contents
Quick start
Connection setup
Ethernet
By default, you can use Ethernet connectivity out-of-the-box without any additional configuring. Plug in an Ethernet cable, and you are connected.
WiFi access point
SLP2 has pre-configured access point mode by default. That is after the first boot, you should see an access point named "Cosmostreamer." Use the "1234512345" password to access it. You can change the access point name and password in the configuration file "cosmostreamer.conf" in the /boot partition of the micro SD card (or eMMC). Here is how this section looks like:
# Wi-Fi access point interface # disabled if empty, int - Internal Wi-Fi, ext - External USB Wi-Fi ap_iface=int # Wi-Fi access point SSID ap_ssid="cosmostreamer" # Wi-Fi access point password ap_psk="1234512345"`
Examples: To disable access point use:
ap_iface=
To enable access point using external WiFi (USB dongle) use:
ap_iface=ext
To enable access point using internal WiFi installed on CM4 use:
ap_iface=int
Note: please check that your USB WiFi dongle supports AP mode and that RaspiOS support the dongle's chipset!