Difference between revisions of "StereoPi v2 Camera Kit Guide"
Jump to navigation
Jump to search
Realizator (talk | contribs) m (→Basic assembly) |
Realizator (talk | contribs) m (→Basic assembly) |
||
Line 16: | Line 16: | ||
[[File:Stereopi-v2-camera-kit-3-1.jpg|none|800px|10mm spacers installation]] | [[File:Stereopi-v2-camera-kit-3-1.jpg|none|800px|10mm spacers installation]] | ||
+ | |||
+ | |||
+ | 3. You should get this assembly as a result: | ||
+ | |||
+ | [[File:Stereopi-v2-camera-kit-3-2.jpg|none|800px|10mm spacers installed]] | ||
=== Cameras installation === | === Cameras installation === |
Revision as of 16:09, 28 September 2021
Contents
Basic assembly
Following this section of the guide, you can assemble the basic camera setup without a screen and a button. This assembly is useful for the OpenCV experiments.
Camera mounting plate preparation
1. Prepare the camera mount plate, four nuts, and four 10mm spacers
2. Install the spacer to the hole in each corner and fix it with the nut
3. You should get this assembly as a result:
Cameras installation
CM4 installation
StereoPi v2 power jumper installation
StereoPi v2 installation
Back plate installation
Tripod mount installation
Advanced assembly
In this section, we'll review a few cameras installation options, as well as 2" IPS screen installation and a shot button. This assembly is suitable for the SLP2 image and stereoscopic photo/video capture.