StereoPi v2 Quick Start Guide
Revision as of 13:33, 22 September 2021 by Realizator (talk | contribs)
How to install RPi Compute Module 4 (CM4)
- Disconnect all external equipment and power.
- Put the board upside down so that the USB C port is facing to the left.
- Take the CM4 module so that the triangle PCB antenna and the power circuit (a group of 5 black components) are faced to the left.
- Put the CM4 module on the connectors and gently press the bottom until you hear a click. After that, do the same with the top part of the CM4.
Power switch
Please install a jumper to the pins near the USB C connector.
Note: advanced users can use external buttons or equipment to turn on/off the board.
How to connect power
We recommend using the UCB C power supply unit.
If the power jumper is installed, the board will boot as soon as you connect the power cable.
Advanced users: you can use either a USB C cable or the JST-EHR2 cable. You can also use them at the same time and hot-swap on the go. YouTube video: Hot Swap Power